HID Xenon Ballast And Bulb Kit For 12-14 Jaguar XFR

You may well have to adjust the headlights after installation. If it's possible, when you take the old assembly out, you should match up the new adjusters with the old ones. Adjust the new light as close to that on the old units as you can. That way, any adjustments you have to make on the car once they are installed will be minimal. Our headlight assemblies have the same or improved adjusters as the stock units, and there are many videos on Youtube on how to adjust lighting. Check your owners manual too, since not all vehicles are adjusted the same way. Finally, when adjusting, make sure your car is level, with a full tank of gas.

HID stands for "High Intensity Discharge". These bulbs use an electric arc rather than the glowing filament in a Halogen bulb. HID headlamp bulbs do not run on low-voltage DC current like a Halogen Bulb, so they require a ballast, which controls and regulates the flow of current. This ballast will require an ignitor to light the bulb. This is either integrated directly into the bulb or as a separate unit which is occasionally part of the ballast, similar to fluorescent bulbs in your home. In a vehicle, HID bulbs tend to be much more expensive to replace than a Halogen bulb.

Replacing stock Halogen headlights with HIDs would require some modifications, especially where the wiring is concerned. While the lamp can sometimes fit into the opening on the front of the vehicle, your stock lamps will use different bulbs, sockets, fuses, relays, and wiring than most HID bulbs. You may want to check with your local mechanic for advice if you have never attempted this type of conversion before.