HID Xenon Ballast And Bulb Kit For 09-12 BMW 750Li

Replacing stock Halogen headlights with HIDs would require some modifications, especially where the wiring is concerned. While the lamp can sometimes fit into the opening on the front of the vehicle, your stock lamps will use different bulbs, sockets, fuses, relays, and wiring than most HID bulbs. You may want to check with your local mechanic for advice if you have never attempted this type of conversion before.

You may well have to adjust the headlights after installation. If it's possible, when you take the old assembly out, you should match up the new adjusters with the old ones. Adjust the new light as close to that on the old units as you can. That way, any adjustments you have to make on the car once they are installed will be minimal. Our headlight assemblies have the same or improved adjusters as the stock units, and there are many videos on Youtube on how to adjust lighting. Check your owners manual too, since not all vehicles are adjusted the same way. Finally, when adjusting, make sure your car is level, with a full tank of gas.

Your headlights will be warm to the touch from the heat generated by the bulb. The filament inside of a headlight bulb can reach temperatures of over 4000º F while the temperature of the glass surface of the bulb can exceed 150º F. This means that heat will naturally radiate to the exterior surface of your headlights. This intense heat is also what will help your headlights remain condensation and moisture free. However, to prevent burns or other injuries, be sure to let bulbs and headlight assemblies cool completely after use before handling.