Front Left Driver Side Signal/Parking Light Assembly for 2008-2012 Jeep Liberty

HID stands for "High Intensity Discharge". These bulbs use an electric arc rather than the glowing filament in a Halogen bulb. HID headlamp bulbs do not run on low-voltage DC current like a Halogen Bulb, so they require a ballast, which controls and regulates the flow of current. This ballast will require an ignitor to light the bulb. This is either integrated directly into the bulb or as a separate unit which is occasionally part of the ballast, similar to fluorescent bulbs in your home. In a vehicle, HID bulbs tend to be much more expensive to replace than a Halogen bulb.

Yes we do. Check out our PERDE Xenon and Krypton bulbs while looking up your vehicle. These cast a brighter, white light that reflects well off the road and allows you to see further in the dark. In most cases, these only use 35 to 65 watts. Here at headlightsdepot.com, we offer a limited Lifetime Warranty on perde bulbs. That's how much we believe in this product!

You may well have to adjust the headlights after installation. If it's possible, when you take the old assembly out, you should match up the new adjusters with the old ones. Adjust the new light as close to that on the old units as you can. That way, any adjustments you have to make on the car once they are installed will be minimal. Our headlight assemblies have the same or improved adjusters as the stock units, and there are many videos on Youtube on how to adjust lighting. Check your owners manual too, since not all vehicles are adjusted the same way. Finally, when adjusting, make sure your car is level, with a full tank of gas.