Headlight Set Bracket Fits 05-10 Chevy Cobalt and 07-09 Pontiac G5

You may well have to adjust the headlights after installation. If it's possible, when you take the old assembly out, you should match up the new adjusters with the old ones. Adjust the new light as close to that on the old units as you can. That way, any adjustments you have to make on the car once they are installed will be minimal. Our headlight assemblies have the same or improved adjusters as the stock units, and there are many videos on Youtube on how to adjust lighting. Check your owners manual too, since not all vehicles are adjusted the same way. Finally, when adjusting, make sure your car is level, with a full tank of gas.

For the most part, no. The stock replacement headlight assemblies are a direct equivalent to what is being taken out of the car. You can reuse your old bulbs and sockets, which should fit right in with no modifications needed. Some of the aftermarket units do use different Halogen bulbs than the stock ones. In those cases, we sell the requisite bulb, and really, with the great deal we have on PERDE light bulbs, you can't go wrong with fresh, new bulbs.

Replacing stock Halogen headlights with HIDs would require some modifications, especially where the wiring is concerned. While the lamp can sometimes fit into the opening on the front of the vehicle, your stock lamps will use different bulbs, sockets, fuses, relays, and wiring than most HID bulbs. You may want to check with your local mechanic for advice if you have never attempted this type of conversion before.