Tail Lights Pair For Nissan Altima 18 Tail Lamp

You may well have to adjust the headlights after installation. If it's possible, when you take the old assembly out, you should match up the new adjusters with the old ones. Adjust the new light as close to that on the old units as you can. That way, any adjustments you have to make on the car once they are installed will be minimal. Our headlight assemblies have the same or improved adjusters as the stock units, and there are many videos on Youtube on how to adjust lighting. Check your owners manual too, since not all vehicles are adjusted the same way. Finally, when adjusting, make sure your car is level, with a full tank of gas.

Your old lights probably had moisture or condensation in them too, but the older, dulled and oxidized lens makes moisture less noticeable. Now that you have those new clear lights on your nice car, all of sudden you’re really looking at them, which is completely normal. Without going into too much detail, It's a fact that condensation happens just about anywhere. If there's a temperature difference between the inside and outside of the lens, moisture will occasionally develop, and, since your Halogen headlight bulbs put out some heat, the inside of the headlight is full of warm air while the outside is cooler. This is sort of like how the front window on your car can fog up and you have to turn on the defroster vent to clear it all away: The condensation in your headlights will usually dissipate after the headlights are turned on, as the heat of the lights evaporates the moisture. Your high beams will usually produce more heat to clear any condensation more quickly.

Halo lights are lights arranged in a ring around the headlights themselves. You've probably seen them on some cars, such as BMWs, where they are the factory option. In some cases the effect is achieved with bulbs, while on other vehicles it's done with fiber optics. Halo Lights can be a popular upgrade to make your car or truck stand out at night. Please be aware that most of theHalo lights we sell typically have to be manually wired up to your existing wiring harness. This is because your stock vehicle did not have Halos, and there is no wiring pigtail for them on the factory harness.